What Position Should I Play In Lacrosse

Your laptop becomes too hot?

Here you have some ideas for a problem I've seen in more than one laptop, and overheating is , if good can be due to more than one cause , but the most common is overheating for bad cooling. What's the problem? because we are used to nuetra desktop pc and when we see that it begins to shut down only if he goes and turns off (which Ehh fucked ), normally we directly to open the box (those who have closed) and open it and just to see the kilos of lint and dust accumulated mainly in the processor heatsink.
also tell you that this is not a tutorial on a laptop in particular, this happens to all the problem is not seeing what is there .

The problem is that in a laptop the "dirt" is not so obvious.
At first it seems all clean some dust but nothing major ... if that what you see ... but how and what is not? Well
explain it better with some pictures:
Well this is the fan that cools the processor (in this case is a ASUS X50 SL ) and as you can see this "clean" the dust that said before but apparently well and when we remove the fan .. .


This is the view when we remove the fan, and the white box indicates the part where dirt accumulates.


As you can see once cleaned, we can see the light.

To clean with a small brush clean and dry, give until you remove it all and you can see the light. Once completed remount the fan and put a lid y. .. ready.
This operation is not others do it once a year so we will not stop lying at a worse time or you queméis fingers typing on a laptop with which you can make a fried egg. I hope you help keep your portable !

Clever Messages To Put On Cell Phones

How to make either a roundabout? Router

After seeing how every time I approach a roundabout, and seeing that more and more of these "crosses" hellish, drivers, doubt, stand like a STOP it were, give the happened to be inside, close to those in the inside lane (and shorter) and a hundred more mischief endangering all of us in a of these crosses. Well here
mean, roughly, how you have to do a roundabout

First example:
This is the easiest example:


If we reach a roundabout and want to take the next exit, right way to do this is: Placing ourselves
in right lane (this must be done in advance) will take the outside lane or more away from the center of the roundabout and we will also by rail the next exit right . very important signal with flashing!

Second example: If
we go straight ...

If our destination is the exit opposite to ours, that is, if we go straight.
We are located in the right lane (we do this in advance), we will take the outside lane or more away from the center of the roundabout and we will also the right lane of the exit opposite. Very important signal to the selected output intermittently! In this case it does not take the roundabout "in the rectum, which is what many drivers do for the simple fact that is shorter or the vagueza not to turn the wheel. With this all we get is impede traffic of which if they do well in addition to being very dangerous for other drivers and of course ourselves.


And now the hard ....
Third example: If you want to take the leftmost exit, go back the same output as it came out or go into the roundabout to decide the output.



If our destination is the exit to the left of our position or if we made a U-turn,
We are located in the left lane (that we do, again, in advance) , will take the inside lane or closer to the center of the roundabout, and will not leave until you reach the selected output. To indicate the intermittent leave right after the exit before the chosen by us (In the graphic example would be the exit opposite to the starting position indicated) The output will gradually, without disturbing the Other drivers found on the roundabout , and if not possible, full turn at the roundabout. outside lane drivers have priority over those who are inside. Well

I hope you find it useful especially the novice, good and not so novice also.
Greetings and careful on the road! By PeYuTrOn

Monowall